www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
74
|
GB
3. Install new table insert.
4. Tighten the screws at table insert.
Brush inspection
Check the carbon brushes after the rst 50 operating hours with a new
machine, or when new brushes have been tted. After carrying out the
rst check, repeat the check every 10 operating hours.
If the carbon is worn to a length of 6 mm, or if the spring or contact wire
are burned or damaged, it is necessary to replace both brushes. If the
brushes are found to be usable following removal, it is possible to rein-
stall them.
When servicing the carbon brushes, open the two latches counterclock-
wise (as shown in gure 21). Then remove the carbon brushes.
Replace the carbon brushes in the reverse order.
Service information
Please note that the following parts of this product are subject to normal
or natural wear and that the following parts are therefore also required
for use as consumables.
Wear parts*: carbon brushes, saw blade, table inserts, sawdust bags
* Not necessarily included in the scope of delivery!
11. Storage
Store the device and its accessories in a dark, dry and frost-proof place
that is inaccessible to children. The optimum storage temperature is be-
tween 5 and 30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust and moisture.
Store the operating manual with the electrical tool.
To Next Page
Loading...
Need help?
General