www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
73
9. Transport
• Tighten the locking handle (11) to lock the rotary table.
• Press the machine head (4) downwards and secure with the locking
bolt (23).
• Fix the saw’s drag function with the locking screw for drag guide (20)
in rear position.
• Carry the equipment by the xed saw table (15).
• When reassembling the equipment proceed as described under chap-
ter 8.
10. Maintenance
m Warning! Prior to any adjustment, maintenance or service work dis-
connect the mains power plug!
General maintenance measures
Wipe chips and dust o the machine from time to time using a cloth.
In order to extend the service life of the tool, oil the rotary parts once
monthly. Do not oil the motor.
When cleaning the plastic do not use corrosive products.
Cleaning the moving saw blade guard safety device (5)
Always check the saw blade guard for debris before using the machine.
Remove old sawdust and splinters using a brush or similar tool.
Replacing the table insert
Danger!
With a damaged table insert (10) there is a risk of small parts getting
stuck between table insert and saw blade, blocking the saw blade.
Immediately replace damaged table inserts!
1. Remove screws at table insert. If required, turn rotary table and in-
cline saw head to be able to reach the screws.
2. Remove table insert.
To Next Page
Loading...
Need help?
General