www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
52
|
GB
3. Scope of delivery
• Sliding cross cut mitre saw
• 1 x Clamping device (7) (preassembled)
• 2 x Workpiece support (8) (preassembled)
• Sawdust bag (17)
• Allen key 6 mm (C)
• Allen key 3 mm (D)
• Sawblade (mounted)
• Operating manual
4. Intended use
The sliding cross cut mitre saw is designed to crosscut wood and plastic
respective of the machine’s size. The sliding cross cut mitre saw is not
designed for cutting rewood.
Warning! Do not use the sliding cross cut mitre saw to cut materials
other than those specied described in manual.
Warning! The supplied saw blade is intended exclusively for sawing the
following materials:
wood, wood-derived products (MDF, chipboard, plywood, blockboard,
hardboard, etc.), wood with nails and 3 mm mild steel plates.
Note: Wood containing non-galvanised nails or screws can also be
safely cut when carefully handled.
Note: Do not use the saw blade to cut galvanised materials or wood
containing galvanised nails. Do not use the saw blade to saw rewood!
The equipment is to be used only for its prescribed purpose. Any other
use is deemed to be a case of misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries of any kind caused
as a result of this.
To Next Page
Loading...
