Scheppach MST254

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
68
|
GB
8.4 Crosscut 90° and turntable 0°−45° (g. 1/7/8)
The sliding compound mitre saw can be used to make crosscuts of
0°−45° to the left and 0° -45° to the right in relation to the stop rail.
Attention! For 90° crosscuts, the moveable stop rail (16a) must be xed
in the inner position.
• Open the set screw (16b) for the moveable stop rail (16a) and push the
moveable stop rail (16a) inwards.
• The moveable stop rail (16a) must be xed far enough in front of the
innermost position that the distance between the stop rail (16a) and
the saw blade (6) amounts to a minimum of 8 mm.
• Before making the cut, check that the stop rail (16a) and the saw blade
(6) cannot collide.
• Secure the set screw (16b) again.
• Loosen the locking handle (11) if tightened, pull up the latched position
lever (35) with your index nger and use the locking handle (11) to set
the rotary table (14) to the desired angle.
• The pointer (12) on the rotary table must match the desired angle on
the scale (13) on the xed saw table (15).
• Re-tighten the handle (11) to secure the rotary table (14).
• Cut as described under section 8.3.
8.5 Precision adjustment of the stop for mitre cut 45° (g. 1/2/5/9/10)
• No stop angle included.
• Lower the machine head (4) and secure it using the locking bolt (23).
• Fix the rotary table (14) in the 0° position.
Attention! For mitre cuts (inclined saw head), the left side of the move-
able stop rails (16a) must be xed in the outer position.
• Open the set screw (16b) for the moveable stop rail (16a) and push the
moveable stop rail (16a) outwards.
• The moveable stop rail (16a) must be xed far enough in front of the
innermost position that the distance between the stop rail (16a) and
the saw blade (6) amounts to a maximum of 8 mm.
• The right side of the moveable stop rails (16a) must be in the inner
positiion.