www.scheppach.com
38
|
GB
15. Troubleshooting
Problem Possible Cause Help
The motor does not run. Faulty motor, power supply cable
or plug. Burned out fuses.
Have the machine checked by skilled
personnel. Do not try to repair the
machine yourselves as it may be dan-
gerous. Check the fuses and replace
them if necessary.
The motor starts slowly and does
not reach running speed.
Low power supply voltage.
Damaged windings. Burned out
capacitor.
Ask for the Electricity Board to check
the voltage available. Have the machine
motor checked by skilled personnel.
Have the capacitor replaced by skilled
personnel.
Excessive motor noise. Damaged windings. Faulty motor. Have the motor checked by skilled
personnel.
The motor does not reach full
power.
Overloaded circuit due to lighting,
utilities or other motors.
Do not use other utilities or motors on
the circuit to which the track saw is
connected.
Motor overheats easily Overload of the motor; inadequate
cooling of the motor
Prevent overloading the motor when
cutting; remove dust from the motor to
ensure an optimum cooling of the motor
Decrease in cutting power when
sawing
The saw blade is too small (sharp-
ened too often)
Re-adjust the end stop of the saw unit
The saw cut is rough or wavy The saw blade is dull; the tooth
shape is not suited to the thick-
ness of the material
Re-sharpen the saw blade or use an
appropriate saw blade
The work piece rips or splinters The cutting pressure is excessive
or the saw blade is not suited to
the application
Use the correct saw blade
To Next Page
Loading...
Need help?
General
