www.scheppach.com
26
|
GB
•
• Open the tank cover (2).
• -
mable solvent.
•
• And then close the tank cover (2).
Changing oil (Fig. 3 - 5)
-
-
ating hours.
operating hours.
The engine oil change should be carried out while the
motor is at operating temperature.
m ATTENTION! Drain petrol before changing oil.
• -
face.
•
screw (a).
•
• Fill up engine oil (approx. 0.25 l)
• Close the cover (19) and tighten the Phillips screw
(a) again.
is too little engine oil. The oil indicator light (7) starts
The in-
The engine switches
Service information
-
or that the following parts are required as consuma-
bles.
m ATTENTION! Danger of burning!
has cooled down before cleaning or maintenance.
m ATTENTION!
-
erating materials to a collection point designated for this
purpose.
-
10 hours.
operating hours.
Please also refer to the service information.
•
screw (a).
• -
ter cover (c).
•
•
•
surface.
•
Spark plug (Fig. 3, 4, 7)
operating hours and clean it with a copper wire brush
•
screw (a).
• Then loosen the spark plug cover (20)
•
motion.
•
wrench (17).
• Assess the condition of the spark plug:
-
service address.
- -
-
- The distance between the electrodes should be 0.6
- 0.7 mm.
•
To Next Page
Loading...
