Scheppach SG3200 - Maintenance; Engine Oil Change; Spark Plug Check and Cleaning

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
30
|
GB
15. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem
if your tool fails to work properly. If the problem persists after working through the list, please contact
your nearest service workshop.
Fault Cause Remedy
Engine will not start
No fuel in the tank. Fill the tank up.
Fuel valve closed. Open the fuel valve.
Air lter dirty. Clean the air lter.
Engine switch is set to "OFF". Set the engine switch to "ON".
Recoil starter defective. Repair the recoil starter.
No engine oil. Rell the engine oil.
Spark plug dirty. Clean the spark plug
Engine oil level too low (oil
warning lamp is ashing).
Rell the engine oil.
On/o󰀨 switch for motor opera-
tion set incorrectly.
Set to the correct position
Engine is running loud-
ly/irregularly
Spark plug dirty Clean/replace the spark plug.
Air lter severely dirty Clean/replace the air lter.
Fuel contaminated/stale Drain and replace the fuel.
Choke lever set to "CHOKE" Set the choke lever to "RUN"
Incorrect fuel - diesel instead
of petrol
Drain the fuel and ll with the correct
fuel
No electrical output
Fault in the a.c. power gener-
ator
For service under warranty, inform
your representative
Engine will not switch
o󰀨
Ignition switch-o󰀨 wire defec-
tive
Close the fuel valve and wait until the
engine shuts o󰀨; call customer service
You can obtain information on collection
points for waste equipment from your mu-
nicipal administration, public waste disposal
authority, an authorised body for the dispos-
al of waste electrical and electronic equip-
ment or your waste disposal company.