Scheppach TIGER 2000S User Manual

www.scheppach.com
20
|
GB
1. Explanation of the symbols on the device
m
Observe warnings and safety instructions!
Read the operating and safety instructions before start-up and follow them!
Wear eye protection!
Wear hearing protection!
If dust builds up, wear respiratory protection!
Danger of injury due to a rotating tool! Keep your hands away.
Keep third-parties away from the danger zone.
Warning! The electrical connection must be established by an electrician and must comply with IEC 364. It is
recommended that a residual current circuit breaker be installed in the electrical connection to this device, which
disconnects the mains voltage if the residual current circuit breaker exceeds 10mA for 30 ms.

Scheppach TIGER 2000S Specifications

General

Grinding Wheel Diameter	200 mm
Grinding Wheel Width	40 mm
Motor Power	120 W
No-Load Speed	120 rpm
Honing Wheel Diameter	200 mm
Honing Wheel Width	30 mm
Grain Size	220