Mark Lock Centerline on Door Face and Door Edge
2
38” from finished floor
Mark and Drill Hole in Door Face with 2¹⁄₈” Hole Saw
3
1
1³⁄₈” - 1³⁄₄”
Measure Door Width
If the door is thinner than 1³⁄₈” or thicker than 1³⁄₄”, then the
lock will not fit properly on the door.
Door Edge
Door Face
Tape
Measure
Tape
Measure
Mark and Drill Hole in Door Edge
4
BE365 Door Preparation Instructions For Door With No Holes
1” Drill Bit
2³⁄₈” or 2³⁄₄”
a
Tape
Measure
d
b
¹⁄₂” Door
Width
Tape
Measure
ba
dc
Tools Needed
Pencil
Drill Bits Needed:
¹⁄₈”, ⁷⁄₈”, 1”
2¹⁄₈” Hole Saw
Chisel
Tape
Measure
Tape Measure
2¹⁄₈” Hole Saw
c
To Next Page