6 Operating Instructions- The bp408 Safety Circuit - General Information
1.2 Intended Use
The safety circuit is an operating resource for use in industrial high-voltage systems
and is used exclusively for the processing of information as part of an elevator
control system.
1.3 Documentation References
This manual does not provide information on our overall delivery options. All
information only serves to describe the product and must not be regarded as
granted characteristics in the legal sense. Any claims for damages against us,
irrespective of the legal basis, are excluded unless we are guilty of deliberate intent
or gross negligence. We do not assume any guarantee that the specified circuits
or procedures are free of copyrights of third parties.
Reproduction, even in extracts, is permissible only with the consent of
Böhnke + Partner GmbH and with precise reference to the source.
Böhnke + Partner logo and company name are protected trademarks.
The information in this manual is regularly checked. The necessary corrections are
included in subsequent editions.
Hazard warnings and special information are given in this technical manual in the
following way and highlighted with a corresponding symbol.
CAUTION!
This symbol is used when inaccurate compliance with or failure to comply with
instructions or procedures can result in damages to the device, injuries, or fatal
accidents.
WARNING!
This symbol is used when inaccurate compliance with or failure to comply with
instructions or procedures can result in injuries or fatal accidents due to electric
current.
NOTE!
This symbol is used to bring attention to a specific characteristic.
To Next Page
Loading...
