schmersal bp408 - Product Certificates; Declaration of Conformity; EU Type Examination

Operating Instructions- The bp408 Safety Circuit - Product Certificates 7
2 Product Certificates
2.1 Declaration of Conformity
The declarations of conformity of the control components used can be found in the
latest versions in our online catalogue in the Lift Technology section at the
documents of the respective component:
https://products.schmersal.com/en_IO/bp408-806.html
:
2.2 EU Type Examination
The system module bp408 contains an electronic monitoring unit for the safety
circuit and a precontrol for the contactors. Moreover, a safety circuit (SMZ) is
located on the circuit board. The safety circuit can be used in the following cases
of DIN EN 81-20/-50 and DIN EN 81-1/-2:
 Preparatory measures with lift car and shaft door open
 Levelling with lift car and shaft door open
 Re-levelling with lift car and shaft door open
 Detection of an unintended movement of the lift car with open doors (UCM).
Figure 1:
Document area in online
catalogue for the bp408