Need help?Do you have a question about the Schmidt SS 20.600 and is the answer not in the manual?
General| Brand | Schmidt |
|---|---|
| Model | SS 20.600 |
| Category | Accessories |
| Language | English |
Explains manual symbols for safety warnings and notes on dimension units.
Details the ATEX version for explosive gas and dust atmospheres, including safety instructions.
Describes the optional oxygen version, its adaptations, and safe handling requirements.
Covers special gas version, Parylene coating for media resistance, and mechanical designs.
Outlines available basic designs: compact sensor and remote sensor.
Provides handling precautions and details the compression fitting mounting method with material variations.
Details safety measures and requirements for mounting the sensor in systems with overpressure.
Specifies thermal boundary conditions and flow characteristics needed for accurate measurements.
Covers sensor head design, measurement direction, and optimal positioning for accurate flow measurement.
Guides on achieving low-turbulence flow by specifying run-in and run-out distances in pipes.
Provides a step-by-step guide for installing the sensor using a compression fitting.
Describes the mounting procedure for the remote sensor version, including bracket use.
Details flow conditions and installation in systems with square or rectangular cross-sections.
Details the pinout of the sensor connector and associated wire colors for proper electrical connection.
Specifies operating voltage, wiring for analog outputs, and mode selection for flow and temperature.
Explains the behavior of analog outputs in short circuit conditions.
Details the technical characteristics and wiring for the first pulse output (PNP).
Describes the technical specifications and wiring for the second pulse output (relay).
Explains the function of the four Duo-LEDs for indicating flow velocity and error states.
Describes analog output switching characteristics and how errors are signaled.
Explains how measuring values are mapped to signaling ranges for flow velocity and medium temperature.
Describes how values exceeding the flow velocity measuring range are handled.
Explains sensor reactions to medium temperatures outside the specified operating limits.
Lists essential mechanical checks before powering on the sensor.
Lists essential checks for the connecting cable and its connection before powering on the sensor.
Discusses operating temperature limits for electronics and potential damage from exceeding them.
Covers suitability for impure gases and precautions regarding deposits and liquids.
Explains sensor head maintenance, cleaning procedures using compressed air and special swabs.
Provides a guide to identifying and resolving sensor errors based on LED indicators and possible causes.
Covers sensor transport precautions, calibration recommendations, and repair policies.
Details available certificates and the process for obtaining factory calibration certificates.
Provides dimensional drawings and specifications for the compact sensor model.
Shows dimensional drawings and specifications for the remote sensor and its mounting bracket.
Lists key measurement parameters like measuring values, medium, ranges, and accuracy.
Details the operating temperature ranges for different sensor parts and the materials used in construction.
Summarizes general specifications including operating pressure, voltage, outputs, connection, and ATEX categories.
To Next Page
