STEUEREINHEIT AIRBASIC 2 –GEBRAUCHSANWEISUNGEN
AIRBASIC 2 CONTROLLER – USER MANUAL
40
P19
Air filter maintenance pre-alarm
hours
h
100 − 9900
1500 1500
P20
Oil filter maintenance pre-alarm
hours
h
100 − 9900
3000 1500
P21
Separator filter maintenance pre-
alarm hours
h
100 − 9900
3000 1500
P22 Oil maintenance pre-alarm hours h
100 − 9900
3000 1500
P23
General maintenance pre-alarm
hours
h
100 − 9900
500 500
P24 Measurement unit for pressure / 0 - 1 0 0
P25 Measurement unit for temperature / 0 - 1 0 0
P26 Automatic restart status / 0 - 1 0 0
P27 Alarm relay function / 0 - 2 0 0
P28 Output OUT1 function / 0 - 2 0 0
P29 Input IN5 function / 0 - 2 0 0
P30 Profile selection / 0 - 1 0 0
P31 Compressor address / 1 - 30 1 1
P32
(4)
Input load/unload remote function
enable
/ 0 - 1 1 1
1
From firmware revision 0.11 this value has been changed from 9 to 8 bar
2
From firmware revision 0.11 the maximum value of this interval has been changed from 3000 to 9900
3
From firmware revision 0.11 the maximum value of this interval has been changed from 1000 to 9900
4
The parameter P32 has been inserted from firmware revision 0.10. When used with pressure switch, it’s
necessary to not modify the default value 1.
To Next Page
Loading...
Need help?
General