User Manual - LLS 3
Page 37
The parameters read or changed are shared with the parameters for RS-232, they are
not independent between control modes. Changing parameters in one control mode will
be seen in the other control modes.
Should a non-Windows Operating System be used with the LLS 3, the LLS 3 can be
controlled without the SDK and using standard TCP socket communication. The
communication protocol over Ethernet utilizes the same commands as the RS-232.
Refer to Section 13.0 for the instructions on the specific commands. Although non-
Windows OS’s are not supported, please contact Technical Support for the basic
method of communicating using standard TCP sockets.
Note: With the unit on an Ethernet network, the front intensity knob will respond slightly
slower compared to when no Ethernet cable is connected. This is normal behavior;
however, the intensity knob does NOT lose any resolution or sensitivity with the
Ethernet cable plugged in. Unplug the Ethernet cable if a quicker response is required.
15.0. Power Supplies
The LLS 3 has a DC Input for Universal 24 Volts and the appropriate power supply
adapter is provided with the unit.
Please note the following:
• Use only the specified AC power supplies to comply with CE regulations
and standards
• If using the Multi-Port connector, then utilize a UL/CSA/CE power supply to
ensure compliance with CE regulations and other safety standards
To Next Page
Loading...
