User Manual - LLS 3
Page 5
1.1. Safety Symbols – English
The following Symbols are used in relation to the LED Light Source.
European Declaration of Conformity
Compliant with the Waste Electrical and
Electronics Equipment/Restriction of the Use
of Certain Hazardous Substances in Electrical
and Electronics Equipment (WEEE/RoHS)
1.2. LED Safety Classification – English
The LED Light Source is classified as a Type 1 LED Product. Do not stare into
the beam. LED output is out of the front nosepiece of the unit. Please follow all
safety and operational guidelines to ensure safe operation of the unit.
1.3. Quick Start – English
1.3.1. Input Voltage
The LLS 3 accepts input voltage up to 35 VDC. DC power for the LED Light
Source must be from an agency approved Class 2 DC power supply. A
suitable 24VDC power supply for 100 to 240 VAC and 50/60 Hz is provided
with the unit. Input voltage can be applied to either the circular DC connector
or the green terminal block (Multi-Port connector). It is advised that the
chassis ground terminal on the Multi-Port connector be attached to a suitable
earth ground.
To Next Page
Loading...
