User Manual - LLS 3
Page 6
1.3.2. Turning the Light Source “On”
1. Connect the cord from the power supply to the light source.
2. The LLS 3’s green status LED will illuminate for a few seconds while the
unit initializes. If the unit is in Standby Mode, then the LED will turn off.
3. Turn the intensity control knob all the way down (to prevent accidentally
shining the optical output onto others).
4. Press the On/Standby push button on the front of the unit.
5. Turn up the intensity control knob.
6. If the light engine does not light up, check the polarity switch setting.
7. To turn the LED Off, press the On/Standby push button on the front of
the unit.
To Next Page
Loading...
