16
OPENING AND CLOSING
To close the chinstrap fastener, slide the ratchet tongue step by step into the
locking buckle. If you nd that the chinstrap ts too loosely around your chin,
slide the ratchet tongue one step further into the locking buckle. When adjusting
the chinstrap, make sure that it rests rmly but not uncomfortably around your
chin. To open the chinstrap, pull the red ribbon on the ratchet fastener upwards
to release the locking buckle. Then pull the ratchet tongue out of the locking
buckle.
Caution:
Never ride without making sure that the chinstrap is correctly fastened
and adjusted and properly positioned. If the chinstrap is not correctly
adjusted or fastened, the helmet could be displaced in the event of an
accident.
Caution:
Never open the chinstrap while riding.
9. VISOR
COATING
The main visor has an anti-scratch coating.
OPENING AND CLOSING
The face shield is opened or closed by grasping
one of the two nger tabs on the face shield
and pushing the face shield up or down into the
desired position.
To Next Page
Loading...
