SC10U
10
6. Insert the control buttons and microphone unit between the
external shell and the left inner shell. Click the snap through its
snap holder.
7. Hide the wires behind the center pad and reinstall the cheek pads.
Note:
If you have trouble inserting the neckroll, lift the battery unit and reinstall the
neckroll while holding them together.
Note:
To enhance the audio quality, you can make use of the foam speaker
covers. Cover each speaker with the foam and attach the hook fastener at
the back of the speaker. Then place the speakers in the helmet as described
above. Foam covered speakers work most effectively when they are slightly
touching your ears.
Hook Fastener
Foam Speaker Cover
To Next Page
Loading...
