SCHUBERTH SC10U - Schuberth SC10 U Configuration Settings

SC10U
33
English
14 CONFIGURATION SETTING
You can set the conguration of the SC10U by the voice menu
instruction described below.
1. To enter into voice conguration menu, press and hold the (+)
Button or the (-) Button for 10 seconds until the LED shows solid
blue and you hear high toned double beeps. You will also hear a
voice prompt, “Conguration menu”.
2. Tap the (+) Button to navigate between the menus. You will hear
voice prompts for each menu item as below.
3. You can enable/disable a feature or execute a command by
tapping the (-) Button.
4. If no button is pressed within 10 seconds, the SC10U will exit the
conguration and go back to stand-by mode.
5. If you want to exit the conguration immediately, tap the (+) Button
until you hear a voice prompt, “Exit conguration”, and tap the
(-) Button.
The voice prompt for each menu item is as below:
(1) Phone pairing (10) Voice prompt
(2) Second mobile phone pairing (11) RDS AF setting
(3) Phone selective pairing (12) Sidetone
(4) Media selective pairing (13) Noise control
(5) Speed dial (14) Delete all pairings
(6) Audio Boost (15) Remote control pairing
(7) VOX phone (16) Universal intercom pairing
(8) VOX intercom (17) Factory reset
(9) HD intercom (18) Exit conguration