SCHUBERTH SC10U - Selective Pairing and Speed Dial Configuration

SC10U
35
English
14.3 Phone selective pairing
Voice Prompt
“Phone selective pairing”
Factory Default N/A
To go into phone selective pairing mode, tap the (+) Button until you
hear the voice prompt, “Phone selective pairing”. Please refer to
section 5.3.2, “HFP for Phone Call Only” for details on phone selective
pairing. If you tap the (+) Button, you can exit from the phone selective
pairing mode.
14.4 Media Selective Pairing
Voice Prompt
“Media selective pairing”
Factory Default N/A
To go into media selective pairing mode, tap the (+) Button until you
hear the voice prompt, “Media selective pairing”. Please refer
section 5.3.1, “A2DP Stereo Music Only” for details on media selective
pairing. If you tap the (+) Button, you can exit from the media selective
pairing mode.
14.5 Assigning Speed Dial
Voice Prompt
“Speed dial”
Factory Default N/A
Execute Tap the (-) Button
1. To assign a phone number as a speed dial, tap the (+) Button until
you hear a voice prompt, “Speed dial”.
2. Tap the (-) Button, and you will hear a voice prompt, “Speed dial
one” and “Phone connected”.
3. Tap the (+) Button to select one of three speed dial numbers and
you hear a voice prompt, “Speed dial (#)”.
4. Call a phone number you want to assign and you will hear a
voice prompt, “Save speed dial (#)”. The phone number is
automatically assigned to the selected speed dial number. Then
the phone call will hang up before being connected.
5. To exit the menu, tap the (+) Button until you hear a voice prompt,
“Cancel”, and tap the (-) Button to conrm. You will then hear a
voice prompt, “Cancel”. If no button is pressed within 1 minute,
the SC10U will exit the conguration menu and go back to stand-
by mode.