OPERATION
FX-209 07/19 Operation Section 4-12
© 2019 Alamo Group Inc.
OPERATION
6.2 Connecting the Mower-Semi Mount & Semi Mount Swing Type
1. Make sure the tractor is equipped with the
correct PTO shaft. Change shafts if needed.
2. Shorten or remove the tractor drawbar to avoid
interference when raising and lowering the
mower.
3. Board the tractor and start the engine. Position
the tractor to the mower with the 3-point lift
arms positioned in between the mower
brackets. Note: Set the 3-point lift control to
“Position Control” so that the lift arms maintain
a constant height when attaching the mower.
See the tractor Operator’s Manual for correct
settings when attaching 3-point equipment.
4. Turn off the tractor engine and dismount.
5. One lift arm at a time, insert hitch pins through
the mower brackets and lift arms. Insert lynch
pins to retain lift arms to the mower.
6. Walk around to opposite side and repeat
procedure for remaining lift arm and hitch pin.
7. NOTE: Only use lower lift arms.
8. Adjust any lower link check chains, guide
blocks, or sway blocks to prevent the mower
from swaying side to side and possible contact
with tractor rear tires.
To Next Page
Loading...