43
Switching on and off:
The machine has been tted with a voltage protection, this protection prevents the machine from unintendedly
being switched on while the machine is connected to the mains voltage.When using the machine in the cut-off
saw automatically position :
1. To switch on the machine press the on/off switch “I”.
2. To switch the tool off, release the on/off switch “O”.
When using the machine in the table saw position:
3. To switch the machine on,set the on/off switch (15) to ‘I’.
4. To switch the machine off,set the on/off switch to ‘0’.
Load protection device:
The machine has been tted with a load protection device. In case of overload the machine is switched off.
1. Let the machine cool down for at least 1O minutes
2. Press the reset button before resuming operation.
Ripping:
Note: Unplug the machine and clean the table before leaving the work area.
Securely clamp the workpiece. Never attempt to saw extremely small workpieces. Use
a push stick when sawing extremely small workpieces.
ATTENTION:
Before sawing, remove all nails and other metal objects from the workpiece, and never
start sawing before the machine reaches full speed.
IMPORTANT
Only leave the machine after switching off and when the saw blade has come to a
complete standstill. Pull down the saw head and press in the locking knob.
ATTENTION:
FIGURE 9.1 FIGURA 9.1
To Next Page
Loading...