Schulz Mitre Saw 8" - Preventive Maintenance; Corrective Maintenance; Environmental Orientations and Recommendations

To Next Page

To Previous Page

10. PREVENTIVE MAINTENANCE

To guarantee the perfect functioning and increase the lifespan of your equipment,

follow the recommendations below:

ATTENTION

Maintenance and cleaning:

Before performing any cleaning or maintenance, unplug the tool from the power grid;

11. CORRECTIVE MAINTENANCE

• Regularly clean lhe ventilation slots.

• Remove ali dust from the housing.

• Regularly check the machine for possible damages.

• Belore use always check the state of the saw blade. Particularly make sure that the saw blade is fastened

rmly and that there is no play on it.

• Before use always check the distance between riving knife and saw blade and between guard and saw blade.

Repairs:

If required to perform any repair or replacement of the electric motor brushes, contact the nearest Schulz assis-

tance. Original parts Schulz must be used. The use of non-original parts results in warranty loss and may cause

damage to the equipment or injury.

To guarantee product SAFETY and RELIABILITY, repairs, maintenance and adjustments must be performed by the

nearest SCHULZ AUTHORIZED DEALER, which uses genuine parts.

Disposal of solid waste (parts in general and product packaging)

The generation of solid waste is an aspect that the user must take into consideration, in the use and maintenance

of his equipment. The environmental impacts can cause signicant changes in soil quality, in the quality of super-

cial and underground water and in the population’s health, through the improper disposal of discarded waste (on

the streets, receiving bodies of water, landlls or vacant lands, etc.).

Schulz Compressores S.A. recommends the management of the waste created by the product since its genera-

tion, handling, transport, treatment until its nal disposal. A proper management must consider the following

steps: quantication, qualication, classication, source reduction, selective collection, recycling, storage, trans-

port, treatment and nal destination.

The disposal of solid waste must be done according to the regulative requirements of the legislation in vigor.

12. ENVIRONMENTAL ORIENTATIONS AND RECOMMENDATIONS