Schumacher BE01255 - USING THE AIR COMPRESSOR

• 9 •
12V DC ESTIMATED RUN-TIMES
APPLIANCE TYPE EST WATTAGE ESTIMATED RUN TIME
Cell phone 4 watts 54 hrs
Fluorescent light 4 watts 54 hrs
Radios, fans 9 watts 24 hrs
Depth nder 9 watts 24 hrs
Camcorder 15 watts 14.4 hrs
Electrical tool 24 watts 9 hrs
Electric cooler 48 watts 4.5 hrs
Car vacuum, air compressor 80 watts 2.7 hrs
NOTE: Actual time may vary. Times are based on a fully charged internal battery.
5.6 USING THE AIR COMPRESSOR
WARNING. Read the instructions of the product to be inated before using the compressor. Avoid
overination; do not exceed the manufacturer’s recommended pressures. Do not leave the air
compressor unattended during use.
1. Remove the air compressor hose from the storage compartment in the back of the portable power.
2. Connect the adapter to the valve stem by threading it onto the end. If necessary, use one of the
additional adapters.
3. Press the
Compressor button.
4. To select the desired PSI, press the “
+” or “
–
” buttons. When done, press the SET button.
5. When the desired pressure is reached, the compressor will turn off. Unthread the connector from the
valve stem.
6. Press the
Compressor button again, to turn off the display and LEDs.
7. Do not run for more than 10 minutes at a time. Allow the jump starter to cool down for 10 minutes
before using again.
8. When nished, return the air compressor hose to the storage compartment in the back of the unit.
9. Allow unit to cool.
10. Recharge the unit before storing.
NOTE: To prevent overheating, the compressor has built-in thermal protection that will turn the compressor
off before it overheats. If the compressor shuts off, wait a few minutes and it will automatically restart when
the compressor cools.
NOTE: When not in use, the compressor will automatically shut off after 2 minutes.
NOTE: The air compressor is rated for 100 PSI maximum.
ESTIMATED TIME FOR INFLATING
Vehicle Tires 13"-16" 6-24 minutes
Bike Tires 1-3 minutes
Sports Balls 30 seconds
Times are approximate. Use the air compressor gauge to ensure
the proper pressure has been reached. Do not overinate.
5.7 BEFORE USING THE CONVERTER
Important Safety Instructions:
1. Keep the portable power well ventilated, in order to properly disperse heat generated while it is in use.
Make sure there are several inches of clearance around the top and sides, and do not block the vents
on the back of the portable power.
2. Make sure the portable power is not close to any potential source of ammable fumes or clothing.
3. Keep the portable power dry.
4. DO NOT allow the portable power to come into contact with rain or moisture.
5. DO NOT operate the portable power if you, the portable power, the device being operated or any other
surfaces that may come in contact with any power source are wet. Water and many other liquids can
conduct electricity, which may lead to serious injury or death.
6. Do not place the portable power on or near heating vents, radiators or other sources of heat.
7. Do not place the portable power in direct sunlight. The ideal air temperature for operation is between
50° and 80° F.
8. Do not use the converter near an open engine compartment where fumes may accumulate.
9. Do not modify the AC receptacle in any way.