Schumacher BE01255 - User Manual

Questions and Answers

R
Ronald ThomasAug 4, 2025
Why won’t my Schumacher BE01255 Remote Starter jump start my car?
- L
  Leah AguilarAug 5, 2025
  If your Schumacher Remote Starter won't jump start your car, there are several potential causes: * The clamps might not be making a good connection. Check the connections to the battery and frame, ensuring they are clean. * The connections could be reversed. Disconnect the portable power and reverse the clamps. * The portable power's battery may not be charged. Press the Battery Status button to check the charge level. * The vehicle's battery might be defective. Have it checked by a professional. * The portable power might not be turned on. Ensure the ON/OFF switch is in the ON position.
E
Edwin HughesAug 9, 2025
What to do if my Schumacher BE01255 won’t power my 12V device?
- A
  Alexandra AdamsAug 9, 2025
  If your Schumacher Remote Starter won't power your 12V device: * Ensure the 12V device is turned on. * Check the battery charge status of the portable power by pressing the Battery Status button. * The 12V device may draw more than 20A or have a short circuit. Disconnect the 12V device. A qualified service person should replace the internal 20A fuse.
S
Samuel BakerAug 14, 2025
Why won’t the battery in my Schumacher BE01255 Remote Starter hold a charge?
- R
  Roy WheelerAug 14, 2025
  If the battery in your Schumacher Remote Starter won’t hold a charge, the battery may be bad and unable to accept a charge. Have the battery checked.
A
Adam LewisAug 20, 2025
What to do if the Schumacher BE01255 Remote Starter alarm is on?
- C
  Colleen JohnsonAug 20, 2025
  If the Schumacher Remote Starter alarm is activated, it might be due to reversed connections. Disconnect the jump starter and reverse the clamps to resolve this.
J
jonathanluceroAug 25, 2025
Why does the Schumacher BE01255 Remote Starter display 'err' when the converter is on?
- A
  andrewdominguezAug 26, 2025
  If the converter is on but the display of your Schumacher Remote Starter shows 'err', it could be due to: * The jump starter battery not being fully charged. Recharge the unit. * The device drawing more than 200W or having a short circuit. Use only devices that draw less than 1.7 amps of AC current.
K
Krista SchmidtAug 29, 2025
How to fix a Schumacher BE01255 compressor that shuts off?
- H
  halexanderAug 30, 2025
  If the compressor on your Schumacher Remote Starter shuts off, it is likely overheated. Allow it to cool for a few minutes before trying again.