How to make Schumacher SSC-1000A SpeedCharge start charging?
If your Schumacher Battery Charger is on but not charging, it might not be in charging mode. Press the DISPLAY MODE button until either the Battery % or Voltage light comes on to initiate charging.
What to do if the green CHARGED light turns on too quickly on Schumacher Battery Charger?
If the green CHARGED light illuminates shortly after connecting your Schumacher Battery Charger to the battery, it's possible the battery is already fully or recently charged, causing a high voltage reading. If the battery is in a vehicle, try turning on the headlights for a few minutes to lower the battery voltage, then attempt charging again. You might also try selecting a lower CHARGE RATE.
Why does the CHECK light keep flashing on my Schumacher SSC-1000A SpeedCharge Battery Charger?
The CHECK (red) light on your Schumacher Battery Charger may flash if the battery doesn't reach full charge within 24 hours. This can occur with very large batteries or battery banks that need more power than the charger can provide in that time, or if the battery is faulty. To resolve this, reset the charger by unplugging it or briefly disconnecting the negative battery clip. If needed, re-select the desired charge rate and battery type.
Why is the current lower than selected on my Schumacher SSC-1000A SpeedCharge Battery Charger?
If the measured current on your Schumacher Battery Charger is lower than what you selected, it could be because the charger has reached the maximum voltage and is reducing the current or has detected an over-temperature condition and reduced the current to cool down. This is a normal operation. Ensure that the charger's side ventilation holes are not blocked and move it out of direct sunlight into a shaded area.
What to do if Schumacher SSC-1000A SpeedCharge indicator lights are erratic?
If the indicator lights on your Schumacher Battery Charger are behaving erratically, it could be due to a button being pressed during plug-in or a defect. Ensure nothing is touching the control panel, then unplug the unit and plug it back in. If the issue persists, consider returning it to the place of purchase for a replacement.
Why Schumacher SSC-1000A SpeedCharge Battery Charger is making clicking sound?
The clicking sound from your Schumacher Battery Charger is normal. It's the sound of a relay turning the current on and off to the battery.
Why does the fan on my Schumacher Battery Charger turn on and off?
The fan turning on and off unexpectedly on your Schumacher Battery Charger is normal. The fan operation is controlled by software and temperature.
Step-by-step guide for charging a battery while it remains installed in the vehicle.
Explains standard charging, auto shut-off, aborted charges, and desulfation mode.
Details on how charging completes and the maintain mode operation.
General| Input Voltage | 120V AC |
|---|---|
| Automatic Shut-Off | Yes |
| Engine Start Function | No |
| Battery Recondition Mode | No |
| Type | Automatic |
| Output Amperage | 10A |
| Voltage | 12V |
| Battery Types Supported | AGM, Gel |
| Safety Features | reverse polarity protection |
| Output Voltage | 12V |
| Charging Amperage | 10A |
| Battery Compatibility | 12V Batteries |
| Charger Type | Battery Charger |
| Display Type | LED |
| Amperage | 10A |
To Next Page