EU Declaration of Conformity
7 EU Declaration of Conformity
Manufacturer/
Distributor
SCHUNK GmbH & Co. KG Clamping and gripping technology
Bahnhofstr. 106 - 134
D-74348 Lauffen/Neckar
We hereby declare on our sole authority that the product meets the requirements of the
following directive at the time of declaration.
The declaration is rendered invalid if modifications are made to the product.
Product designation: Force-torque-sensor FT
This declaration of conformity applies to all variants mentioned in
chapter 1.1.3 of the corresponding instructions.
Electromagnetic compatibility (EMC Directive) 2014/30/EU
Applied harmonized standards, especially:
EN 61326-2-3:2013 Electrical equipment for measurement, control and laboratory
use - EMC requirements – Part 2-3: Particular requirements – Test
configuration, operational conditions and performance criteria for
transducers with integrated or remote signal conditioning. (IEC
61326-2-3:2012)
EN ISO 12100:2010 Safety of machinery - General principles for design -
Risk assessment and risk reduction
All related technical documentation has been prepared in electronic form according to
Directive 2014/30/EU and will be made available to national authorities on demand. The
signatory is resident at the manufacturer's address and is authorized to compile this
documentation.
Signed for and on behalf of: SCHUNK GmbH & Co. KG
Dr.-Ing. Manuel Baumeister,
Technology & Innovation,
Mechatronics & Sensors
Lauffen/Neckar, May 2021
5503.00 | FT | Assembly and Operating Manual | en | 389582
To Next Page
Loading...
