Initial commissioning and normal operation
QM.UC.00002-R3.0 |en
17
CAUTION
Risk of injury due to workpieces coming undone due to a faulty
display of the magnetic system.
• Ensure that the workpiece is properly clamped on the magnetic
chuck (for example with the steel tip of a screwdriver), by tak-
ing the suitable safety precautions!
6 Carry out a demagnetization cycle.
REMARK
For a proper connection of the external control signals, please
refer to the specific wiring diagram the control unit is supplied
with.
7 Make sure that the workpiece has been released from the
magnetic chuck.
8 Remove the workpiece from the magnetic chuck.
9 Please contact SCHUNK if the expected results are not
achieved even after having strictly followed the a.m. steps.
PLEASE NOTE
Please always have the serial no. at hand when contacting SCHUNK
about technical matters!
To Next Page
Loading...
Need help?
General
