QM.UC.00002-R3.0 |en
23
Disposal
This product is made of plastic, electrical, and electronic compo-
nents. If it is taken out of operation, it has to be disposed of in
compliance with the applicable regulations.
As soon as the end of the lifecycle has been reached, the control
unit has to be decommissioned, i.e. put into a state in which it can
no longer be used for its original intended use and in which it is
still possible to recycle the raw materials contained.
NOTE
SCHUNK GmbH & Co. KG assumes no liability for material damage
or personal injury that may result from reusing individual compo-
nents of the control unit for purposes other than the original in-
tended use! SCHUNK GmbH & Co. KG provides neither implicit nor
explicit declarations about possible usability of recycled compo-
nents after decommissioning the control unit.
Procedure for final decommissioning and disposal of the control
unit:
CAUTION
Risk of injury.
Decommissioning, disassembly and disposal of the control unit
must be performed by qualified persons using suitable tools.
1 Ensure that the machine tool has safely come to a halt. Dis-
connect all the electrical, hydraulic and pneumatic connec-
tions that could cause unexpected movements of the machine
or its components.
2 Disconnect the product from all devices.
Have the control unit disposed of by a company specialized
in the disposal of electrical equipment.
11
To Next Page
Loading...
Need help?
General
