QM.UC.00002-R3.0 |en
5
Basic safety notes
Intended use
This control unit has exclusively been designed for the operation of
SCHUNK electro-permanent magnetic chucks, during the use of
which it is essential, that the time between two ON/OFF cycles is
not less than 3 minutes.
This control unit has furthermore been designed for the installa-
tion inside the electrical cabinet of machine tools for the clamping
and machining of workpieces and must operate in dry interiors
with a relative air humidity of 5-15 % (max. 50% at 40°, without
condensation) and an ambient temperature of 5°-40°C.
The requirements of the applicable standards must be observed.
The control unit may only be used in the context of its defined ap-
plication parameters.
For its intended use it is also essential to observe the technical da-
ta, the installation and operation notes as well as the maintenance
intervals indicated in the present manual.
DANGER
Danger to short circuit
• The control unit must be installed inside the electrical cabinet
of the machine tool and must always be protected against wa-
ter and/or operating fluids from the machine and protected
against metal chips.
NOTE
be placed in service until the machine
tool, for which the controller is provided, satisfies the require-
ments of the Machinery Directive 2006/42/EC!!
Environmental and operating conditions
• Use the control unit only within its defined application parame-
ters. "Technical data" ( 5, Page 10).
• Make sure that the environment is clean and the ambient tem-
perature corresponds to the specifications.
2
2.1
2.2
To Next Page
Loading...
Need help?
General
