SCHUNK KEH-P User Manual

Initial commissioning and normal operation
QM.UC.00002-R3.0 |en
19
8 Make sure that the workpiece has been released from the
magnetic chuck.
9 Remove the workpiece from the magnetic chuck.
10 Please contact SCHUNK if the expected results are not
achieved even after having strictly followed the a.m. steps.
NOTICE
Damage to the magnetic chuck due to overheating
The control unit has been designed for cycle times (magnetization
and demagnetization) of at least 3 minutes to avoid overheating
of the magnetic chuck ( 5, Page 10). Non-observance of these
instructions may cause irreversible damage to the magnetic
chucks and render the warranty void!

SCHUNK KEH-P Specifications

General

Brand	SCHUNK
Model	KEH-P
Category	Control Unit
Language	English