What to do if the LED on SCHUNK MEG 50 EC Industrial Equipment controller flashes continuously (approx. 4 times every 1 sec.)?
If the LED on your SCHUNK Industrial Equipment controller flashes continuously about 4 times every second, it indicates an overcurrent warning. To resolve this, lower the gripping force set value.
Why is the LED on my SCHUNK Industrial Equipment controller flashing continuously (approx. once per sec.)?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once per second, it could be due to the gripper not being connected or a cable breakage. Check the connection of the gripper to the controller, ensuring it is correctly connected. Also, check the coil resistances of the motor cables to each other; it should be around 8.2 Ohm.
What causes the LED on SCHUNK Industrial Equipment controller to flash continuously (approx. once every 2 sec.)?
If the LED on your SCHUNK Industrial Equipment controller flashes continuously about once every 2 seconds, it means the controller temperature is too high. Try lowering the gripping force set value and ensure the controller has sufficient cooling.
What to do if the LED on SCHUNK Industrial Equipment controller flashes continuously (approx. once every 4 sec.)?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once every 4 seconds, it indicates an under- or overvoltage issue. Check the power supply to the controller.
What to do if the LED on SCHUNK Industrial Equipment does not light up after switching on?
If the LED on the SCHUNK Industrial Equipment controller does not light up after switching on, it indicates there is no power supply. Check the power supply to the controller.
How to fix a SCHUNK MEG 50 EC Industrial Equipment controller when the LED doesn't flash 6 times on startup?
If the LED on the SCHUNK Industrial Equipment controller does not flash 6 times briefly when switching on, it indicates there is no power supply. Check the power supply to the controller and avoid repeated switching off and on of the power supply.
What to do if the LED on SCHUNK MEG 50 EC controller flashes continuously (approx. once per sec.) because fingers are mechanically jammed?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once per second, and the fingers are mechanically jammed, check whether the adapter plate is stepped, especially if it's a lateral attachment.
Defines required personnel qualifications for product operation.
Details required personal protective equipment (PPE) for safe operation.
Provides essential guidelines for safe handling and operation.
Overview of fundamental hazards and safety measures.
Safety measures for product handling and assembly.
Safety measures during commissioning and operation.
Measures to prevent injuries from unexpected movements.
Precautions for electrical hazards and static electricity.
Highlights specific risks: voltage, loads, falling objects, movements.
Details on how to mechanically connect the gripper.
Specific dimensions and mounting details for the gripper.
Information on mounting the MEG C controller.
Guidelines for electrical connections.
Pin assignment for the gripper's device plug.
Detailed terminal functions and cable colors for the MEG C 50.
General| Nominal voltage | 24 V DC |
|---|---|
| Stroke per jaw | 6 mm |
| Material | Aluminum alloy |
| Weight | 0.6 kg |
| Operating temperature | 5-60 °C |
To Next Page
