SCHUNK MPG Series - User Manual

Questions and Answers

A
Amanda JohnsonJul 28, 2025
What to do if SCHUNK MPG Industrial Equipment is not moving?
- M
  Mr. Joe AdamsJul 28, 2025
  If your SCHUNK industrial equipment isn't moving, there are several potential causes: * The base jaws may be jammed in the housing due to an uneven mounting surface. Ensure the mounting surface is sufficiently even. * The pressure may have dropped below the minimum required. Check the air supply. * The compressed air lines might be switched. Verify the compressed air lines are correctly connected. * The proximity switch could be defective or incorrectly set. Readjust or replace the sensor. * Unused air connections may be open. Close any unused air connections. * The flow control valve may be closed. Open the flow control valve. * A component part may be defective. Replace the component or send it to SCHUNK for repair.
W
William PrattAug 7, 2025
Why is SCHUNK Industrial Equipment not executing the complete stroke?
- A
  Alice Roberts MDAug 7, 2025
  If your SCHUNK industrial equipment isn't completing its full stroke, consider these possible reasons: * Dirt deposits may have accumulated between the cover and piston. Clean and re-lubricate the affected area. * Dirt deposits might be present between the basic jaws and guidance. Disassemble and clean the product. * The pressure could be dropping below the minimum required. Check the air supply. * The mounting surface may not be sufficiently flat. Check the evenness of the mounting surface. * A component part may be defective. Replace the component or send it to SCHUNK for repair.
N
Nathan ValdezAug 17, 2025
How to prevent SCHUNK MPG from opening or closing abruptly?
- W
  Wayne WrightAug 17, 2025
  To prevent abrupt opening or closing of your SCHUNK industrial equipment, consider the following: * Insufficient grease in the mechanical guiding areas can cause this issue. Clean and lubricate the product. * Blocked compressed air lines can also be a cause. Check the compressed air lines for damage. * An uneven mounting surface may contribute to the problem. Check the evenness of the mounting surface.