Maintenance
38
09.00 | MPG | Assembly and Operating Manual | en | 389213
7.3 Lubricants/Lubrication points
SCHUNK recommends the lubricants listed.
During maintenance, treat all greased areas with lubricant. Thinly
apply lubricant with a lint-free cloth.
Lubricant point Lubricant
Metallic sliding surfaces microGLEIT GP 360
All seals Renolit HLT 2
Bore hole at the piston Renolit HLT 2
7.4 Disassembling and assembling
WARNING
Risk of burns through contact with hot surfaces!
Surfaces of components can heat up severely during operation.
Skin contact with hot surfaces causes severe burns to the skin.
• For all work in the vicinity of hot surfaces, wear safety gloves.
• Before carrying out any work, make sure that all surfaces have
cooled down to the ambient temperature.
To Next Page
Loading...
Need help?
General
