What to do if the LED on SCHUNK MEG 64 EC controller flashes continuously (approx. 4 times every 1 sec.)?
If the LED on your SCHUNK Industrial Equipment controller flashes continuously about 4 times every second, it indicates an overcurrent warning. To resolve this, lower the gripping force set value.
Why is the LED on my SCHUNK MEG 64 EC Industrial Equipment controller flashing continuously (approx. once per sec.)?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once per second, it could be due to the gripper not being connected or a cable breakage. Check the connection of the gripper to the controller, ensuring it is correctly connected. Also, check the coil resistances of the motor cables to each other; it should be around 8.2 Ohm.
What causes the LED on SCHUNK MEG 64 EC controller to flash continuously (approx. once every 2 sec.)?
If the LED on your SCHUNK Industrial Equipment controller flashes continuously about once every 2 seconds, it means the controller temperature is too high. Try lowering the gripping force set value and ensure the controller has sufficient cooling.
What to do if the LED on SCHUNK MEG 64 EC Industrial Equipment controller flashes continuously (approx. once every 4 sec.)?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once every 4 seconds, it indicates an under- or overvoltage issue. Check the power supply to the controller.
What to do if the LED on SCHUNK Industrial Equipment does not light up after switching on?
If the LED on the SCHUNK Industrial Equipment controller does not light up after switching on, it indicates there is no power supply. Check the power supply to the controller.
How to fix a SCHUNK Industrial Equipment controller when the LED doesn't flash 6 times on startup?
If the LED on the SCHUNK Industrial Equipment controller does not flash 6 times briefly when switching on, it indicates there is no power supply. Check the power supply to the controller and avoid repeated switching off and on of the power supply.
What to do if the LED on SCHUNK Industrial Equipment controller flashes continuously (approx. once per sec.) because fingers are mechanically jammed?
If the LED on the SCHUNK Industrial Equipment controller flashes continuously approximately once per second, and the fingers are mechanically jammed, check whether the adapter plate is stepped, especially if it's a lateral attachment.
General| Brand | SCHUNK |
|---|---|
| Model | MEG 64 EC |
| Category | Industrial Equipment |
| Language | English |
To Next Page
