SCHUNK MPG Series User Manual

Name: SCHUNK MPG Series
Brand: SCHUNK
Rating: 5 (1 reviews)

48 pages

To Next Page

To Previous Page

General

09.00 | MPG | Assembly and Operating Manual | en | 389213

1.1.2 Applicable documents

• General terms of business *

• Catalog data sheet of the purchased product *

• Assembly and operating manuals of the accessories *

The documents marked with an asterisk (*) can be downloaded on

our homepage schunk.com

1.1.3 Sizes

This operating manual applies to the following sizes:

• MPG 16

• MPG 20

• MPG 25

• MPG 32

• MPG 40

• MPG 50

• MPG 64

• MPG 80

1.1.4 Variants

This operating manual applies to the following variations:

• MPG without gripping force maintenance

• MPG with gripping force maintenance "O.D. gripping" (AS)

• MPG with gripping force maintenance "I.D. gripping" (IS)

• MPG high-temperature (V/HT)

• MPG-FPS

1.2 Warranty

If the product is used as intended, the warranty is valid for 24

months from the ex-works delivery date under the following

conditions:

• Observe the specified maintenance and lubrication intervals

• Observe the ambient conditions and operating conditions

Parts touching the workpiece and wear parts are not included in

the warranty.

1.3 Scope of delivery

The scope of delivery includes

• 2-Finger Parallel-Gripper MPG in the version ordered

• Assembly and Operating Manual

• Accessory pack

Questions and Answers:

A
Amanda JohnsonJul 28, 2025
What to do if SCHUNK MPG Industrial Equipment is not moving?
- M
  Mr. Joe AdamsJul 28, 2025
  If your SCHUNK industrial equipment isn't moving, there are several potential causes: * The base jaws may be jammed in the housing due to an uneven mounting surface. Ensure the mounting surface is sufficiently even. * The pressure may have dropped below the minimum required. Check the air supply. * The compressed air lines might be switched. Verify the compressed air lines are correctly connected. * The proximity switch could be defective or incorrectly set. Readjust or replace the sensor. * Unused air connections may be open. Close any unused air connections. * The flow control valve may be closed. Open the flow control valve. * A component part may be defective. Replace the component or send it to SCHUNK for repair.
W
William PrattAug 7, 2025
Why is SCHUNK Industrial Equipment not executing the complete stroke?
- A
  Alice Roberts MDAug 7, 2025
  If your SCHUNK industrial equipment isn't completing its full stroke, consider these possible reasons: * Dirt deposits may have accumulated between the cover and piston. Clean and re-lubricate the affected area. * Dirt deposits might be present between the basic jaws and guidance. Disassemble and clean the product. * The pressure could be dropping below the minimum required. Check the air supply. * The mounting surface may not be sufficiently flat. Check the evenness of the mounting surface. * A component part may be defective. Replace the component or send it to SCHUNK for repair.