Steps 3 - 4
2. Skip to the Inspect the cable connection at the handlebar steps in the next section to continue
troubleshooting.
If both the console and handlebar buttons do not adjust incline:
1. Let's start another workout, this time checking if the incline motor moves when
using the Incline Quick Level buttons.
2. After each button is pressed, listen for movement or noise from the incline motor.
3. Press the Incline Quick Level 5 button on the left side of the console.
4. Next, we will press the Incline Quick Level -5 button.
Incline motor can be heard moving briefly, but reverts to the original position:
We'll calibrate the incline using this guide - Schwinn 490 Elliptical: Incline Calibration
Procedure
If the issue persists after recalibrating the incline, order an Incline (Lift) Motor [15333.K].
If there is no noise or movement from the incline motor:
We'll check the input/output cable connections first, then the incline adjuster assembly if the
issue continues.
Checking the handlebar cable is not needed for this scenario.
Skip to the Check the console cable connection steps to continue troubleshooting.
To Next Page
Loading...
