Schwinn 490e - Page 32

32
Sensor Hub to
Upper Handle-
bar Buttons
Cable
Inner Pivot
Shroud
Inner Pivot
Shroud
10. Slide the Lower Handlebar outward only about 1 inch
(2.5 cm) from the machine.
11. PushtheInnerPivotShroudtowardthemachine,o󰀨of
the Lower Handlebar. This will release the Cable from the
clips on the Inner Pivot Shroud.
12. With the wire or string still attached to the end of the
Cable, pull the cable down into the machine from the
Handlebar. Be sure not to pull the end of the wire or string
into the Lower Handlebar.
9. Usinga6mmhexwrench,removethehardware
(indicated by oval) that secures the Lower Handlebar.
Sensor Hub to
Upper Handle-
bar Buttons
Cable