Schwinn 490e - Page 68

68
5. Usinga6mmhexwrench,removethehardware
(indicated by ovals) that attaches the Pedals and remove
them.
There is also a Wave Washer on the post from the
Pedal.
Note: With the Pedal removed, do not fully rotate the
Lower Handlebars or damage to the cables in the
Handlebars will occur.
6. Usinga6mmhexwrench,removethehardware
(indicated by an oval) from the Legs and remove them.
Note: To assist with re-assembly, notice there is a Wave
Washer on the post from the Crank Arm.
Pedal
Pedal
Pivot Pin
Leg
Leg
Note: To assist with re-assembly,
notice that the Pivot Pin is flush
with the outside of the Lower
Handlebar.
X2
*
11
6mm
X2
*
X2
X2
**
B
6mm
C
Crank Arm