Schwinn IC7 - Page 5

5
&KHFNLQJWKH'ULYH%HOW7HQVLRQ
To test the Drive Belt tension, sit on the bike and use the pedals at approximately 20 RPM. Then accelerate quickly
(speed burst) to your maximum ability and feel whether the Drive Belt slips. If the pedals move normally with no skipping
(slip), the tension is correct. If the Drive Belt slips, refer to the “Adjust the Belt Tension” procedure in this manual.
/HYHOLQJWKH0DFKLQH
The machine needs to be leveled if your workout
area is uneven. Levelers are found on each side
of the stabilizers. Lift the stabilizer slightly to take
WKHZHLJKWRႇWKHDGMXVWHUWKHQWXUQWKHNQREWR
adjust the stabilizer foot.
'RQRWDGMXVWWKHOHYHOHUVWRVXFKD
KHLJKWWKDWWKH\GHWDFKRUXQVFUHZIURP
WKHPDFKLQH,QMXU\WR\RXRUGDPDJHWR
the machine can occur.
Make sure the machine is level and stable before
you exercise.
0RYLQJDQG6WRULQJWKH0DFKLQH
To move the bike, carefully pull the Handlebars toward you while pushing the front of the bike downward. Push the bike to
the desired location.
NOTICE:%HFDUHIXOZKHQ\RXPRYHWKHPDFKLQH$EUXSWPRWLRQVFDQDႇHFWWKHFRPSXWHU
operation.
)RUVDIHVWRUDJHRIWKHPDFKLQHUHPRYHWKHEDWWHULHV3ODFHWKHPDFKLQHLQD
secure location away from children and pets.
(PHUJHQF\6WRS
To stop the pedals immediately, push down hard on the Brake/Resistance Adjustment Knob.