Scientific
PSD7303 21/42
2.5 CH1/CH2 Parallel mode
Instruction
In the parallel mode, CH1 and CH2 are linked internally into one channel
which is controlled by CH1. Its output current value is twice as much as
the single
channel.
Output rating 0~32V/0~6.4A
Operation steps:
1. Press the “Para” button to start Parallel mode, the indicator light
turns bright immediately and the logo “ ”display at the top of
screen.
2. Connect the load to the positive and negative terminal of CH1；
3. Set voltage and current value:
a) Press “1” button to select the channel 1
b) Move the cursor through direction button to select the
wanted parameter(voltage, current),
c) Press “Fine” to select the digit position and then revolve
the multi-function knob to change the corresponding parameter.
4. Press “on/off” button corresponding CH1 to turn on the output
Note: You can identify the current working state “CC” or “CV” by referring
to indicator light of CH1/CH2.(red means CV, green means CC)；
In parallel
mode, CH2 only works in CC mode.
To Next Page
Loading...