SCION xA (EM00D0U)
119
The current is applied at all times through the STOP fuse to TERMINAL 2 of the stop light SW.
When the ignition SW is turned to ON position, the current from the GAUGE fuse flows to TERMINAL 5 of the shift lock
control SW.
Shift Lock Mechanism
With the ignition SW at ON position, when a signal that the brake pedal is depressed (Stop light SW on) and a signal that the
shift lever is put in P position (Continuity P SW) is input to the shift lock control SW, the shift lock control SW operates and
the current flows from TERMINAL 5 of the shift lock control SW to TERMINAL SLS+ to the shift lock solenoid to TERMINAL
SLS– of the shift lock control SW to TERMINAL 1 to GROUND. This causes the shift lock solenoid to turn on (Plate stopper
disengages) and the shift lever can shift into position other than P position.
: Parts Location
Code See Page Code See Page Code See Page
S4 31 S6 31
Junction Block and Wire Harness Connector
Code See Page Junction Block and Wire Harness (Connector Location)
1B 24 Engine Room Main Wire and Instrument Panel J/B (Lower Finish Panel)
1O
To Next Page
Loading...
Need help?
General
