144
SCION xA (EM00D0U)
Two Way Flow Heater
When all of the following conditions are met, the recirculation/fresh air inlet damper is switched to the DUAL MODE position.
∗ The recirculation/fresh air switch is at FRESH position
∗ The blower SW is on.
∗ The max hot SW is on.
∗ The foot mode SW is at FOOT or F/D position.
: Parts Location
Code See Page Code See Page Code See Page
A8 30 B4 30 J7 31
A17 A 30 C7 30 J8 31
A18 B 30 F12 30
B3 30 I12 31
Junction Block and Wire Harness Connector
Code See Page Junction Block and Wire Harness (Connector Location)
1H
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
Instrument Panel Wire and Instrument Panel J/B (Lower Finish Panel)
Connector Joining Wire Harness and Wire Harness
Code See Page Joining Wire Harness and Wire Harness (Connector Location)
IG1 37 Instrument Panel Wire and A/C Sub Wire (Right Kick Panel)
Ground Points
Code See Page Ground Points Location
IE 36 Left Kick Panel
IG 36 Right Kick Panel
System Outline