Changzhou Sciwil E-Mobility Technology Co., Ltd.
9
th
Huashan Road, Changzhou, Jiangsu, China- 213022
Fax: +86 519-85602675 Tel: +86 519-85600675
The driving speed will be kept constant as the limited value.
Error Value: ±1km/h (applicable to both the PAS/throttle mode)
Note: The above-mentioned values are measured by metric unit (kilometers).
When the measuring unit is set to imperial unit (mile), the speed
displayed on the panel will be automatically switched to corresponding
imperial unit, however the speed limit value in the imperial unit interface
won’t change accordingly.
P09: Direct Start / Kick-to-Start Setting
0: Direct Start (Throttle-on-demand); 1: Kick-to-Start
P10: Drive Mode Setting
0: Pedal Assist – The specific gear of the assist drive decides the assist power
value. In this status the throttle does not work.
1: Electric Drive – The vehicle is driven by the throttle. In this status the power
gear does not work.
2: Pedal Assist + Electric Drive – Electric drive does not work in direct-start status.
P11: Pedal Assist Sensitivity (Range: 1-24)
P12: Pedal Assist Starting Intensity (Range: 0-5)
P13: Magnets Number in Pedal Assist Sensor (5 / 8 / 12pcs)
P14: Current Limit Value (12A by default; Range: 1-20A)
P15: Unspecified
P16: ODO Clearance
Press and hold the up key for 5 seconds and ODO distance will be cleared.
P17: Cruise (0: without cruise function, 1: with cruise function)
1.3.5 Communication Protocol: UART