6
Changzhou Sciwil E-
Mobility Technology Co., Ltd.
9
th
Huashan Road, Changzhou, Jiangsu, China- 213022
Fax: +86 519-85602675 Tel: +86 519-
P04: Auto-Off Time
(0: never, other value means time interval for display auto-off) Unit: minute
P05: Pedal Assist Level
0/3 Gear Mode: Gear 1-2V, Gear 2-3V, Gear 3-4V
1/5 Gear Mode: Gear 1-2V, Gear 2-2.5V, Gear 3-4V, Gear 4-3.5V, Gear 5-4V
P06: Wheel Size (Unit: inch Precision: 0.1)
P07: Motor Magnets Number (for Speed Test; Range: 1-100)
P08: Speed Limit Range: 0-50km/h, no speed limit if set to 50)
1. Communications status (controller-controlled)
The driving speed will be kept constant as the limited value.
Error Value: ±1km/h (applicable to both the PAS/throttle mode)
Note: The above-mentioned values are measured by metric unit (kilometers).
When the measuring unit is set to imperial unit (mile), the speed
displayed on the panel will be automatically switched to corresponding
imperial unit, however the speed limit value in the imperial unit interface
won’t change accordingly.
P09: Direct Start / Kick-to-Start Setting
0: Direct Start
1: Kick-to-Start
P10: Drive Mode Setting
0: Pedal Assist – The specific gear of the assist drive decides the assist power
value. In this status the throttle does not work.
1: Electric Drive – The vehicle is driven by the throttle. In this status the power
gear does not work.
2: Pedal Assist + Electric Drive – Electric drive does not work in direct-start status.
P11: Pedal Assist Sensitivity (Range: 1-24)
P12: Pedal Assist Starting Intensity (Range: 0-5)
P13: Magnets Number in Pedal Assist Sensor (5 / 8 / 12pcs)
To Next Page
Loading...
Need help?
General
