3. Key Operation
Key operation guide as follows:
Press and Hold: means press and hold the key(s) for more than 2s.
Press: means press the key(s) for less than 0.5s.
3.1 On/Off
Turn on the Display: When the display is off, press and hold the Mode Key
to turn on the display, it will show boot interface and then enter riding
interface. (If boot password is activated, enter the boot password at start).
Turn off the Display: When the display is on, press and hold the Mode Key,
the display will be turned off. If no operation is engaged for 10min (0km/h),
the display will be auto-off. Auto-off time can be set in the Settings.
3.2 Assist Level
Press the Up Key or Down Key to switch assist levels. There are 5 levels by
default: 0/1/2/3/4/5. 0 means no assist power.
3.3 Toggle Displays
When the display is on, press the Mode Key to toggle among ODO (total
range), Trip (single trip range), TIME (riding time) etc.
3.4 Light On/Off
Turn on the Front Light: when the front light is off, press and hold the Up
Key to turn it on, and the light icon will be shown on the riding interface (to
remove this functions, please reconfigure the controller).
Turn off the Front Light: when the front light is on, press and hold the Up
Key to turn it off, and the light icon will be off on the riding interface.
3.5 Walk Assist Mode
Engage Walk Assist Mode: On the riding interface, press and hold the
Down Key to enter walk assist mode. Hold the Down Key to engage walk
assist mode, the walk mode icon will be shown on the riding interface, the
To Next Page
