-
10
if there’s no operation for 10s.
4.2 Setting Items
P01: Backlight Brightness. 1: darkest; 5: brightest.
P02: System Unit. 0: km (metric); 1: mile (imperial).
P03: Auto-Off Time
0: never, other value means auto-off time interval. Range: 0-60, Unit:
minute
P04: Pedal Assist Level
0-3 Level Mode
；
1-3 Level Mode (no Level0)
0-5 Level Mode；1-5 Level Mode (no Level0)
P05: ODO Clearance. Press and hold the Up key for 5s and ODO value
will be cleared. Press and hold the Down key for 5s for factory reset.
P06: Voltage Sampling: 0: Controller sends volt data,
Error Value: ±1km/h (applicable to both the PAS/throttle mode)
P09: Boot Password.
Range: 0-50; Unit: inch; Increment: 0.1.
P08: Speed Limit.
1: display sends volt data.When selecting 1, long press the“+”key
to select the 36V/48V/52V voltage level
P07: Wheel Size. Password 1919 is required to unlock this setting.
Range: 0-60km/, communications status (controller-
controlled). The max speed will be kept constant at the set value.
4-Digit. If forget the password, press the Down
key 5 times and then press the Up key 1 time at boot to start.
You may set the password as 0000 to cancel the boot password.
To Next Page
