12
PREPARING CAPPUCCINO
Assemble the automatic milk froth system as described in the “Assembling the automatic milk frothing
system” section, on page 11 of this instruction manual.
1. Fill the milk container with milk and close the lid.
2. Place a cup under the spout.
3. Switch on and press the Cappuccino button . The button will light up, indicating the
process is starting. The indicator will stay on during the preparation process.
4. The machine will dispense coffee first and then milk.
5. The preparation will stop automatically. The drink is ready when the machine returns to the
standby position and the light below the cup goes out. If you want to stop your drink sooner,
press the button again during the operation.
Note: If you want to use the milk container several times within 1 hour, remove the milk container from
the machine and put it in the refrigerator.
Then press the button once to perform a quick cleaning of the system.
If you no longer want to use the milk container (or you wish to use it later than 1 hour), it is imperative
to refer to the chapter "Complete cleaning of the milk accessories".
Note:
Clean the automatic milk frothing system before using it for the first time.
Use cold (at a temperature of about 5°C/41°F), semi-skimmed or even whole milk for optimal foaming
results. Do not use skimmed milk.
Warning:
Steam and hot milk may escape from the nozzle when starting to brew the drink.
Place the flexible milk hose around the lid of the milk container after use.
To Next Page
Loading...