18
3. Reposition the automatic milk frothing system inside the adjustable spout
B- CLEANING THE MILK CONTAINER AND THE MILK TUBE
1. Empty the milk from the milk container and wash it with hot soapy water.
2. Remove the rigid tube, the connector of the milk container’s lid, the flexible milk tube and
the cover to wash them in hot soapy water, then reassemble them.
To make sure the hose holes are clean (see illustration below), use the spiral needle or brush
(supplied with the machine) to clean them.
C- CLEANING THE MILK CIRCUIT
1. Connect the milk container to the coffee machine as described in section "Assembling the
automatic milk frothing system" on page 11.
2. Place a large cup under the spout.
3. Fill the milk container with cold tap water.
4. Double press the clean button and wait.
5. The machine will distribute hot water and steam to wash all parts used for milky drinks.
6. As soon as half of the milk container (filled with water) has been used, press the button
again to stop the cleaning cycle.
7. Switch off the device by pressing the on / off button.
To Next Page
Loading...