ScreenBeam 1100 Plus - II.2 Connecting the Receiver to a Network; II.2.1 Wired Connection

quick start guide
To Connect over the LAN
1.
Connect the ScreenBeam receiver to a known network where
your client device can communicate over Wi-Fi.
2.
Verify the receiver obtained an IP address (shown on the Ready
to Connect screen).
3.
Connect the client device to the same network as ScreenBeam
receiver
4.
To display wirelessly, you need to find the receiver on the
network connection (i.e. Select the ScreenBeam receiver name
as shown on the display)
z For Windows 10 hit the Windows key and K at the same time.
z For iOS or macOS Connect with from the menu bar or
control center.
5.
Enter in the PIN if required. If the PIN code is not displayed, try
the default PIN 1234.
6.
Select duplicate or extended screen mode if prompted.
7.
If the display has touch functionality, Windows 10 devices can
take advantage of the touch and inking feature by selecting
check box for HID devices described above.
10 | screenbeam.com